Housing: Die-cast aluminum. Head assembly is mounted directly to lower housing with three (3) stainless steel screws
Finish: Highly weather-resistant CraftStone™ finish bonded to the aluminum substrate, or durable thermoset polyester powdercoat applied after a fivestage conversion cleaning process. Additional finishes, consult factory.
Socket: Incandescent and HID: medium base. Fluorescent: GX24q-3 or GX24q-4 base.
Gasketing: Flat silicone gasket.
Mounting: Lower casting is secured to anchor foundation by three (3) galvanized steel bolts and nuts. Before installing anchor bolts, contact factory for latest mounting template.
Reflector: Highly reflective white paint on spun aluminum rings, mounted on the underside of louvers.
Transformer/Ballast: HID ballasts are HPF core and coil, factory wired and tested, mounted to a key-slotted removable tray with quick disconnect for easy installation. 120/12V integral transformer is electronic. Fluorescent ballast is electronic (-20° F cold weather start). Ballasts shall provide +/-% lamp power regulation with +/-10% input voltage regulation.
Electrical: Standard quad-volt core and coil mounted on removable ballast bracket, with quick connect harness, high power factor, dipped in moisture-resistant epoxy coating. Fluorescent uses electronic ballasts.
Optics: Die-cast aluminum louvers with clear molded glass, threaded against silicone gasket for tight seal.
Additional Information: LOWER HOUSING – Constructed of 5" diameter extruded aluminum (1/8" walls).